Hello everyone, can someone help me create a diagram of the circuit on livewire or proteus, the following are instructions as to what the circuit should entail.?

Design and construction of an indicator through the activation of three loads with AC, using Flip-Flops - Type T.

Objective:
Design and build a circuit that features a load activation process, where through the MOC (3011) and TRIAC (2N6073) configuration, three loads of electrical and electronic devices are activated.

Constraints:
- Complete methodology implementation.
- The truth table is fully realized, analyzing the entire sequence.
- Exclusive use of digital gates (74LSXX), without the use of any microprocessor, pre-designed circuits, or assembled commercial modules.
- Assembly of an alternating current circuit for the three loads.
- Circuit assembly using a 5V voltage source (TTLs).
- Circuit employing color coding, aesthetics, clarity on breadboard, and the respective formulas of each variable.

EXERCISE 1:
- Clock configuration: 5 seconds.
- It includes an operator control button for the indicator.
- The indicator is normally in green (Load 1).
- When the operator presses and releases the button: one cycle in green (load 1), four cycles in yellow (load 2 and heat resistance), two cycles in red (load 3).
- When the operator presses the button and does not release it: one cycle in green, four cycles in yellow (heat resistance), two cycles in red, and remains in red until the button is released.
- The yellow bulb (load 2) and the heat resistance (load 2) are connected in parallel.