angelmunoz69 angelmunoz69

19-06-2024
Engineering

Answered

The type of bend used to cross rectangular ductwork is a(n):

A. kick
B. offset
C. saddle
D. ell

Answer :

Other Questions

How might the steep escarpment depicted in the illustration have been formed?

If the supreme court accepts an appellate case, what must the attorney for each party then do? how much time does each side receive when they argue their case a

ind the Perimeter of the figure below, composed of a rectangle and a semicircle. Round to the nearest tenths place.

1. Which of the 9 points are not feasible combinations? 2. Which of the 9 points are feasible, but inefficient? 3. If society is presently producing 200 units

Which action would the nurse take for a toddler with autism spectrum disorder who is sitting in a corner rocking and spinning a top? a) Redirect the behavior to

Que sucede si para clavar una puntilla le aplico poca fuerza al martillo?

What is plotted on the coordinate plane? (Give explanation too so I can understand because I’m surprisingly bad at math :( )

A fireman climbs a 10 m high ladder carrying a 5 in diameter hose that has a 1.5 in diameter nozzle. The pump has an absolute pressure of 3 atm . What is the wa

What does a diagram look like for 8/6

What is the magnitude (size) and direction of the cumulative force acting on the car shown in the picture above? A. 2500 N down B. 30 N to the left C. 30